Hook up subs to stock radio, adding subwoofer to stock car radio polk audio

Wiring Subwoofers to stock Radio Interior
Video of the Day
  • Make sure this wire is safe from any moving objects.
  • What do you need to hook up a printer?
  • That this is because you will get distortion and it will not sound good.
  • How do you hook up a radio to a chrysler new yorker?

Buy a new radio and install it. That is because a standard head unit on your radio plays a very wide range of sounds. Will the wires still match up on the aftermarket radio I purchased? Music is like candy, tips on dating an engineer you have to get rid of the rappers to enjoy it.

Go to Radio Shack or Best Buy and get a wiring harness that plugs directly into the car harness. Anybody have any idea which wires I would need to tie in to? This could be caused by a bad ground. You need to do your research though and pick out the right amp for the job.

Report Abuse

Lightly sand the contact area to expose clean metal before attaching ground. Figure out where you're going to place the amp, put the beginning of your power red wire there and give it about a foot of wire extra, then begin to hide and run the power wire to under the hood. Yes, but you will need an auxiliary cable. Mount the antenna to the truck and run the coax to the radio following a path that does not cause interference with other functions like seat adjustment or the pedals.

Make sure that you use cables with the correct resistance or impedance for your setup. One thing to remember though with this answer is it does not mean you can connect the subs directly to the head unit on your stereo. Then you have to find the output wires for the sound range that you need and connect them to the input of the amplifier.

If you installed a powered sub, you will not need to connect the amplifier and speaker, as they are already connected. Have your power wire taunt and find out where your cap. One other key thing to remember about the wires is the more powerful of an amp you went with, the thicker and stronger wires you will need from the amp to the sub. Subwoofers can be large speakers that are usually housed in speaker enclosures installed in the trunk of the car.

Warnings Be careful when around the electrical system of your car. So you are wanting to upgrade your cars sound system, but maybe you are low on funds. It will just plug into your truck and then connect color coordinated wires. Factory radio wiring diagram for a Mazda truck? Also, ar ar dating range you can get amps with low-pass filters and high-pass filters.

Recent Posts

Hook up Subwoofers to Chevy Cobalt? Choose a subwoofer speaker system and amplifier that fits your car's current system and meets your audio needs. That is because the sound is going thru it before getting to your subs. This converter can then be connected directly to your amplifier's line level inputs. The wire from the antenna itself has nothing to do with raising and lowering the antenna.

How do you hook up subwoofers to an stock radio

Make sure you always turn off your amp when you leave your car, it will overheat and drain your battery. Your much better off just getting the deck with the dash mount and wiring harness so it makes hook-up easier and allows you to swith back to stock incase you decide to sell the vehicle later on. Where do I hook up the orange wire when installing an aftermarket radio in a dodge Dakota? Adding a subwoofer and amplifier to your existing stereo is a great way to improve the bottom-end output of your system and is one of the most common upgrades performed on a car's audio gear.

They are connected in series. Get your capacitor as close to the amp as possible, and use the same ground as you did for the amp. The wires are not grounded properly, check to make sure the surface is clean, unpainted metal. There should be a black ground wire in the Chevy Celebrity radio wiring harness.

You could add additional subs to your system using these outputs. You can look up the model of your car and the stock stereo and probably find a guide online to help you with the wiring in an amp. The motor that raises and lowers the antenna is controlled by a wire which is connected to the power switch in the stock radio. The Stock radio has two holes on either side of the unit.

How to Hook Up a Subwoofer System to a Car s Stock Stereo

Where do you hook up a second bass speaker to my sony surround sound? How do you hook up subwoofers in a car? You took your stock radio out of your jeep and you cant figure the wiring to hook up a after market radio you need a diagram if possible? Where can you find a cheap radio that supports subs? Yu can hook subs up any where but to a stock the power output wont be much so they wont really hit.

Include your email address to get a message when this question is answered. How do you connect subwoofers without all the wires? Hi, dating mormon I was wondering how difficult it is to add a sub to a factory car radio? Once you got everything wired you may be wondering what to do next.

How to Wire an Amp & Subwoofers Into a Stock Stereo

Just match the positive and negatives. Turn the gain all the way down, start playing music and turn it up to where you usually listen, where the mids sound good. You want an amp more powerful than your sub, because you don't want your sub to clip. To really highlight the bass of your car stereo, dating simpsons you need a setup capable of properly reproducing low frequency notes. Good luck it will make a huge improvment.

Adding subwoofer to stock car radio Polk Audio

Connect your amplifier to your speaker by running the positive and negative speaker wires to the proper terminals on your speaker. Can you hook up subwoofers and amp to a factory stereo in a Toyota Camry? If you're using an after market head unit, go to an electronics store's stereo department and ask for a wiring harness from your car to the after market head unit. Don't forget to test your rem wire before you assume it works.

Well, most subs get mounted in the trunk because if you are using a strong enough amp you will be able to hear them just fine. The fuse amperage should match the gauge size. You would be best to tie into the rear channel, this can be done the stock head unit.

  1. Did I need to put fuse between the first and second battery?
  2. Where can you find radio wiring diagram for a Chevy Impala ls?
  3. Subs and amps should be matched as closely as possible for best performance and longevity.
  4. This will come into play later.
  5. All you need to do is get a rca wire, cut in half, strip both the outer and inner wire.

How do you hook up subwoofers to an stock radio

Can You Hook Subs To A Stock Stereo

Can you Hook Subs to a Stock Stereo? Its a manual that tells you how to hook up and external amp to your stock system. So, some of the money saving of not having to get a new radio can be used to get a good amp for your subs.

Locate an appropriate place to mount the radio. Already answered Not a question Bad question Other. Getting this wrong may well overheat cables or even blow the amp itself so make sure your cables and setup are matched.

If all connections seem correct but the speaker is not functioning properly, consult an expert at your local electronics store. Can i hook a sub up to that or do i need to get an aftermarket radio? Can you hook a ipod up to a car radio? The sub cuts on and off at high volume when I use the auxiliary cord to phone. Your amp cuts off when you hook it up to your subwoofers?

Quick Links

  • Battle creek dating
  • 100 free online international dating service
  • Beginning dating questions
  • African men dating african american women
  • Payment online dating site
  • The best and safest dating sites